pp-rc Forum

[colmar702]

Hey friends,

short question please: To save time I would like to charge 2 LIPOS each with 6s and 5.000mAh (one normal heavy duty LIPO and one new graphene LIPO).

Both LIPOS would be connected to separate balancer outlets and are of same voltage rating (6*4,2 Volt) = 25,2V.

Can this safely be done with the Pulsar 3+? Sonething I have to watch out?`

Thanks for sharing your experiences.

Colmar

[pp-rc]

Hello,

if they have similar parameters (and starting voltage) then there is no problem (I am talking here about charging as 12S.). If not, there may not be much gain in charging time. The balancer can slow down the process to equalise the voltages.

Best regards

Piotr
pp-rc Modellbau

[colmar702]

Ah GREAT ! They are very similar in specs including internal resistance. Good to read that there is no risc to damage the charger or the battery in principal.

Thx for the fast and great support.

Colmar